Spring and early summer in Victoria bring plenty of sudden downpours, and the first rain after a dry spell is often the most slippery. Oil and rubber that have built up on the road surface lift with the water, and if your tyres can't clear that water fast enough, you can lose grip without warning. That's aquaplaning, and the good news is that most of the risk comes down to things you can check and control.
What actually happens when you aquaplane
Your tyres' tread grooves are designed to channel water out from under the contact patch, the small area of rubber actually touching the road. When there's more water than the tread can move, a thin film builds up and the tyre starts to ride on top of it instead of the bitumen. At that point steering, braking and accelerating all stop working the way you expect.
You'll usually notice it as a sudden lightness in the steering, the engine revs rising without the car speeding up, or the back of the car feeling loose. It can happen in a split second, especially through puddles, wheel ruts or low spots where water pools.
The three biggest factors
1. Tread depth
The legal minimum in Australia is 1.5 mm, measured at the tread wear indicators moulded into the grooves. But wet-weather grip starts dropping well before that point. A tyre that's legal can still struggle to clear water at highway speeds, so if you do a lot of driving in the rain, it's worth thinking about replacement once you're getting down towards 3 mm rather than waiting for the indicators.
2. Tyre pressure
An under-inflated tyre flattens out and the grooves partly close up, so they can't move water as effectively. Check your pressures at least once a month when the tyres are cold, using the figures on the placard inside the driver's door or in the owner's manual, not the maximum number printed on the sidewall.
3. Speed
The faster you go, the less time your tread has to push water aside. Slowing down is the single most effective thing you can do in heavy rain. Speed limits are set for good conditions, so driving below the limit in a downpour is sensible, not overly cautious.
Practical tips for driving in the wet
- Increase your following distance. Stopping distances are much longer on wet roads, so give yourself at least double your usual gap, more in heavy rain.
- Avoid standing water where you safely can. Drive in the tyre tracks of the car ahead, where water has already been pushed aside, and steer around obvious puddles if there's room to do so without swerving.
- Turn off cruise control. You want full control of the throttle so you can ease off smoothly if you feel the car lose grip.
- Be smooth. Gentle steering, braking and acceleration help the tyres keep what grip they have. Sudden inputs are what tip a car into a slide.
- Turn your headlights on. It helps other drivers see you through spray and gloom.
- Never drive into floodwater. It's impossible to judge the depth or whether the road beneath has washed away. If it's flooded, forget it.
If you start to aquaplane
It's a frightening feeling, but staying calm makes a real difference. Ease off the accelerator gradually and keep the steering wheel pointed where you want to go. Avoid slamming on the brakes or jerking the wheel, because when the tyres suddenly regain grip, any sharp input can send the car off in an unexpected direction. If you need to brake, do it gently; if your car has ABS, firm, steady pressure is fine and the system will do its job.
Other things worth checking
Uneven tyre wear can leave one part of the tread much shallower than the rest, so a tyre that looks fine on the outer edge might be close to bald on the inside. Run your hand across the full width of each tyre, or have a look at the inner shoulder with a torch. Worn wiper blades and a grimy windscreen also make wet driving harder, so they're worth sorting at the same time.
Tyre choice matters too. Some tyres are designed with deeper or wider channels specifically for wet performance, which can be worth considering if you regularly drive country roads or highways in the rain.
A quick wet-weather checklist
- Tread depth comfortably above the 1.5 mm minimum on every tyre, across the full width
- Pressures set to the placard figure, checked cold
- No uneven wear, bulges or cuts
- Wipers clearing the screen cleanly
- Lights all working
If you're not sure whether your tyres are up to the wet season, the team at Global Tyres Geelong in North Geelong is happy to check your tread depth and pressures and let you know honestly where things stand, so you can head into the rainy days with confidence.
